Rooting Hiby R6 III possible with Fastboot Enhance.
Mar 23, 2023 19:37:43 GMT
via mobile
NPAudio likes this
Post by veighttripledivision on Mar 23, 2023 19:37:43 GMT
Hiby posted 1.11 firmware link on Facebook.
drive.google.com/drive/folders/1H_G-_uh9SNFoXnpJNcDBo5RgM6Ygknh_?usp=share_link
You extract payload.bin, dump boot.img, patch it with Magisk and flash it then ( I deleted -cow partitions, don't know if it is a must.)
After flashing I had a panick, because my R6 III would only show HIBY boot logo, then turn off. It happened few times in a row, but then finally booted. No issues after, rebooted quite a couple of times, without problems.
AccA did not work for me, but I found some config files that did allow me to limit charge current. Max charge voltage also has a limit file, which is edited when you alter the slider in battery settings (Max battery).
input_current_limited set to "400000" sets me to some ~360mA max current. "1400000" results in 1.22A for me. Don't know if it's the data type, or if my USB tester is not precise.
I would love to have an option to suspend charge until the battery voltage drops to certain value, but I don't think I can achieve it with default control files.
drive.google.com/drive/folders/1H_G-_uh9SNFoXnpJNcDBo5RgM6Ygknh_?usp=share_link
You extract payload.bin, dump boot.img, patch it with Magisk and flash it then ( I deleted -cow partitions, don't know if it is a must.)
After flashing I had a panick, because my R6 III would only show HIBY boot logo, then turn off. It happened few times in a row, but then finally booted. No issues after, rebooted quite a couple of times, without problems.
AccA did not work for me, but I found some config files that did allow me to limit charge current. Max charge voltage also has a limit file, which is edited when you alter the slider in battery settings (Max battery).
input_current_limited set to "400000" sets me to some ~360mA max current. "1400000" results in 1.22A for me. Don't know if it's the data type, or if my USB tester is not precise.
I would love to have an option to suspend charge until the battery voltage drops to certain value, but I don't think I can achieve it with default control files.
