|
Post by nashed on Jun 24, 2023 5:48:31 GMT
Hi Steve,
I need another time your advice. After a software update my Hiby R6 2020 freeze. I used the last advice to shut it down. Now it start and after showing the logo twice it freeze. I have tried a Factory reset (Power button and the one following together ) it start , show the logo twice and freeze. What can I do? Your help is greatly appreciated.
Best regards Kamil
|
|
|
Post by NPAudio on Jun 25, 2023 9:59:04 GMT
Hi Steve, I need another time your advice. After a software update my Hiby R6 2020 freeze. I used the last advice to shut it down. Now it start and after showing the logo twice it freeze. I have tried a Factory reset (Power button and the one following together ) it start , show the logo twice and freeze. What can I do? Your help is greatly appreciated. Best regards Kamil Hi Kamil, I am sorry to hear about your R6 2020. Do you mean you went into recovery mode and chose from the menu 'Wipe Data/Factory Reset' ? i might have some firmware for the R6 2020 to try flash from Recovery or extract some partitions from to flash from QFIL. I'm not sure if have QFIL setup and the correct drivers etc.
|
|
|
Post by nashed on Jun 25, 2023 15:10:47 GMT
Hi Steve, Thanks for responding. I didn't even get to the recovery mode to choose "wipe data/Factory reset". I push the up button (the one near the power) together with the Power and keep pushing, It start with the Logo, disappear short the Logo came back and stay and do not change to recovery mode.
|
|
|
Post by altharic on Jun 30, 2023 11:07:44 GMT
On my Tempotec there isn't a recovery however you can get it to the point it tries to boot in press volume up and power when the logo appears keep the up button pressed and let go of the power see if that works.
|
|
|
Post by NPAudio on Jul 6, 2023 9:38:25 GMT
Hi Steve, Thanks for responding. I didn't even get to the recovery mode to choose "wipe data/Factory reset". I push the up button (the one near the power) together with the Power and keep pushing, It start with the Logo, disappear short the Logo came back and stay and do not change to recovery mode. Hi nashed, can you get into EDL mode and do you have QFIL set up ? I can share the full firmware to flash via QFIL
|
|