|
Post by NPAudio on Nov 8, 2020 19:25:31 GMT
Neotech flat/foil wire in, just need to do the balanced out caps, battery and shape the copper back now.
|
|
|
Post by NPAudio on Nov 8, 2020 21:13:27 GMT
|
|
|
Post by NPAudio on Nov 8, 2020 21:45:50 GMT
|
|
|
Post by nc8000 on Nov 8, 2020 21:48:58 GMT
So you are now using the slightly lower capacity AK battery ?
|
|
|
Post by NPAudio on Nov 8, 2020 22:14:05 GMT
No it's the same WiTBAT which was a replacement/upgrade for the AK240 battery. Not sure you can even buy an AK240 original battery anymore.
|
|
|
Post by NPAudio on Nov 8, 2020 22:16:34 GMT
Weight is now over half a Kilo for the 1Z Stock weight is 455g
|
|
|
Post by frost15 on Nov 8, 2020 22:49:56 GMT
Weight is now over half a Kilo for the 1Z Stock weight is 455g View AttachmentNice, I like my daps like my women... THICC! ๐
|
|
maxx134
Hardware Mods Private
Posts: 84
|
Post by maxx134 on Nov 12, 2020 15:26:19 GMT
The lastest refinements to your mod are unreal... I noticed your using even more capacitance on power cap, and the higher voltage specs of all the lastest cap choices. Do they add to more dynamics or any perceived increased power? I feel that if Mrwalkman was ever able to increase the software volume limit, it would go higher without distorting if the player had this upgrade implemented.
|
|
|
Post by NPAudio on Nov 12, 2020 22:25:09 GMT
The lastest refinements to your mod are unreal... I noticed your using even more capacitance on power cap, and the higher voltage specs of all the lastest cap choices. Do they add to more dynamics or any perceived increased power? I feel that if Mrwalkman was ever able to increase the software volume limit, it would go higher without distorting if the player had this upgrade implemented. Thanks man. Both dynamics and power, Its a small improvement but an improvement none-the less ๐๐ I dare say there may be some configurable output power parameters somewhere.
|
|
|
Post by nc8000 on Nov 12, 2020 22:42:56 GMT
Looking forward to getting mine back
|
|
|
Post by NPAudio on Nov 15, 2020 23:24:51 GMT
|
|
|
Post by frost15 on Nov 16, 2020 13:38:50 GMT
NPAudio Do you recommend activating the "Charge only to 90%" option in the device after the mod is done?
|
|
|
Post by NPAudio on Nov 16, 2020 14:04:08 GMT
NPAudio Do you recommend activating the "Charge only to 90%" option in the device after the mod is done? I would let it run down to 1 bar and then charge it full once on your WM1 to calibrate with your WM1 before activating the 90% feature. I would also recommend a smart charger that will stop charging when full.
|
|
|
Post by frost15 on Nov 16, 2020 15:11:27 GMT
By the way, it's true that the 1Z got a bit fattier, because now it won't completely fit in its benks transparent silicon case haha!
|
|
|
Post by Ghostsounds on Nov 16, 2020 16:27:00 GMT
You must have burnโt all your candles at both ends ๐
|
|